Front Load Washer Leaks Water
Are you using too much detergent?
Using too much detergent can cause over-sudsing, which can cause splashing and overflow, leaving water and soap on the floor and looking like a leak. Be sure to use the proper amount of soap, according to the detergent packaging.
Is the machine overloaded?
Overloading the machine can also cause splashing and overflow, leaving wet floor that looks like a leak. Make sure you don't put too much clothes in the machine.
Important: Unplug the washer from its power source before starting any inspection or repair work.
The hoses are the most common points of failure for a leaking machine. Washing machines employ multiple hoses, though the likely problems would come from the fill hoses or the drain hose.
The fill hoses go from the water source to the water inlet valve. These are in the rear of the machine. Pull the machine from the wall and check that these hoses are fine. The hoses should be kink-free and damage-free. If they are, next check the rubber washer inside. Disconnect the hoses and inspect. If the hose or washer is damaged, replace them.
If it's not the cold or hot fill hoses, check the drain hose next. This is connected to the drain pump, toward the front bottom of the machine. Remove the front panel and inspect the hose for a good connection and for cracks or perforation.
There are other internal hoses to inspect, such as the tub-to-drain hose. If any hose is damaged, do not try to repair and reuse it. Replacement is the recommended solution.
A broken drain pump is another common cause of leaks. All water travels through this part, so if there's a hole or crack in it, it's going to allow water to leak. If there isn't visible problem with the pump, but it still leaks, it's likely the bearings. When a drain pump leaks, there is no repair solution. The only option is to replace it with another.
Washing machines rely on several seals. There is the tub seal, tub spin seal, and door seal. Each plays a part in keeping water from leaking anywhere. The seals are rubber and susceptible to rips, tears, and holes.
When a seal is damaged, the best route to take is replacement. Replacing a seal will require disassembly of the machine. Replacing the door seal is fairly easy, while the tub seal is more difficult.