Front Load Washer is Too Noisy

  • Troubleshooting

    Video Tutorial


    Is the washer level?

    If the washer is not level, there may be excessive vibration, or the drum may make contact with the cabinet, producing a loud, clanging sound. Level the washing machine by adjusting the feet.

    Are there foreign objects in the washer, such as coins or toys?

    Be careful to empty all pockets before loading clothes, and make sure no hard objects are included in the load.

    Tub Bearing and Seal

    Important: Unplug the washer from its power source before starting any inspection or repair work.

    The tub bearing is a part on both front load and top load washers. This bearing allows the wash basket to move freely during the agitation and spin cycles.

    On a front load washer, there are usually two bearings, both located in the rear of the outer tub. The bearings are sealed to keep water from entering, but over time and repeated use, the seal can wear down and water, soap, and dirt can seep in. When that happens, the bearings will eventually fail.

    When the tub bearing is the problem, your machine will make a loud rumbling noice during the spin cycle. If you hear that noise, you can inspect the machine by checkin the tub for excessive play. If you're able to move the tub up and down, and side to side, that can indicate a tub bearing issue.

    Further inspection and repair requires disassembly of the machine. You'll need to remove the outer tub and wash basket in order to diagnose. If replacing the tub bearing, the tub seal should be replaced as well.

    Drain Pump and Motor

    The drain pump pushes water out of the machine for draining. Under normal circumstances, the pump should run sliently. If it's not, it's possible a foreign object such as a wire or small toy is stuck inside. After removing the power, carefully remove the front panel to access the pump. Inspect it for foreign objects and check the impeller for damage. If necessary, replace the pump.

    Some machines have the pump and motor in a single unit. On these, the entire assembly will need to be replaced.

    Shock Absorbers

    Shock absorbers are attached to the outer tub and machine base, and come into play during spinning. In the spin cycle, these parts dampen the tub movement, preventing it from bottoming out and crashing into the cabinet. If the shock absorbers are worn or damaged, they won't do their job, and as the tub hits the cabinet, you'll hear a loud banging during the spin.

    Check the shock absorbers for damage by looking for leaking, broken attachments, and weakness. Replace both, if you determine that one or both are faulty.